Open late: Mon–Fri 9 AM–7 PM · Sat 9 AM–6 PMNew & used equipment · Free local delivery $500+ · Repair · We buy used(945) 394-0396

How to Choose a Walk-In Cooler for a Restaurant, Grocery or Convenience Store

A plain-English guide to sizing, panels, floors, refrigeration and doors, with a checklist and the federal rules that apply.

By Q Restaurant Supply, Irving, TX · Updated November 13, 2026. General guidance only. Always confirm details for your own kitchen and local code requirements.

A walk-in cooler is often the biggest piece of refrigeration you’ll buy for a restaurant, grocery store or convenience store. Get it right and it quietly protects your inventory for years. If you buy one too small, you’ll run out of room on delivery day. Go too big and you’re paying to cool empty air. This guide covers the decisions that matter most, using guidance from walk-in manufacturers, the U.S. Department of Energy and the FDA Food Code.

Q Restaurant Supply sells new walk-in coolers and freezers and installs them in Irving and across Dallas–Fort Worth. See our walk-in coolers page or call (945) 394-0396.

Start with what you’re storing and how often you get deliveries

Before you think about dimensions, answer three questions:

  1. What will go inside? Produce, dairy, meat, beverages, or a mix. Coolers and freezers need different refrigeration, panels and floors.
  2. How often do deliveries arrive? If you get trucks every two or three days, you need room for the largest delivery plus whatever’s already on the shelves.
  3. What temperature does product arrive at? U.S. Cooler notes that many cooler refrigeration packages are sized on the assumption that product comes in at about 55°F and the box holds at 35°F. Freezer packages typically assume product enters at 20°F and holds at -10°F. If your product comes in warmer, such as freshly cooked food or warm beverage cases, the refrigeration has to be sized for that load.

Food safety drives all of this. The FDA Food Code says cold-held time/temperature control for safety (TCS) foods must stay at 41°F or below. A walk-in that can’t recover quickly after the door has been open during a big delivery puts that at risk.

Plan for usable space, not just box size

Shelving, aisles and door swing take up a big share of a walk-in’s floor. Lay out your shelving on paper before you pick a size, and leave room to walk and rotate stock (first in, first out). If you expect your menu or store to grow, it’s usually easier to size up now than to add a second box later.

Indoor or outdoor?

Indoor and outdoor walk-ins are built differently. U.S. Cooler points out that an outdoor box needs weather protection, such as a rain roof or weather ceiling strips. Outdoor refrigeration also needs a weather cover and all-weather controls. An indoor walk-in won’t perform properly outside without that extra equipment. In a hot climate like North Texas, check the ambient temperature rating on the refrigeration spec to make sure it was sized for summer conditions.

Leave clearance around the box as well. U.S. Cooler recommends at least 2 inches around the exterior for airflow so the panels don’t sweat.

Panels and insulation

Walk-ins are built from insulated panels that lock together, usually with foam insulation between metal skins. Finishes can include galvanized steel, aluminum and stainless steel.

Federal rules set a minimum. Under the Department of Energy’s walk-in standards (10 CFR 431.306):

  • Walls, ceilings and doors must be insulated to at least R-25 for coolers and R-32 for freezers.
  • Freezer floors must be insulated to at least R-28.
  • Walk-in doors need automatic closers, plus strip doors, spring-hinged doors or another way to limit warm air getting in when the door is open.
  • Evaporator and condenser fan motors and interior lighting have to meet efficiency requirements.

Thicker panels cost more up front but reduce the load on the refrigeration system for as long as you own the walk-in.

Floor or no floor?

This depends on where the walk-in sits:

  • Walk-in freezers almost always need an insulated floor unless an insulated concrete slab with thermal breaks is already in place (U.S. Cooler).
  • Walk-in coolers set indoors on a bare concrete slab often don’t need a floor.
  • A walk-in placed above grade, over a basement or on an upper floor, needs an insulated floor.

If you’ll be rolling heavy carts or pallet jacks in and out, ask about floor options built for that traffic. Q’s install doesn’t include concrete work, so slab work is a separate job for your contractor.

Self-contained vs. remote refrigeration

This is one of the biggest choices you’ll make.

Self-contained systems

The condensing unit and evaporator coil come as one package, usually dropped into a pre-cut hole in the ceiling or wall. Norlake notes they’re easier to install and a good fit for smaller kitchens and tight spaces. The trade-off is that their heat and noise stay in the room around the box.

Remote systems

The coil goes inside the box and the condensing unit sits outside or in a mechanical room, connected by refrigerant lines. According to Norlake, this keeps heat and noise out of the kitchen or sales floor and suits larger or high-demand walk-ins. U.S. Cooler notes that remote systems are charged with refrigerant on site and need a licensed refrigeration contractor, and that manufacturers usually require a licensed installer to keep the warranty valid.

For a busy kitchen or a store where the box is next to customers, remote refrigeration is often worth considering. For a smaller footprint, a self-contained unit may be simpler.

Doors: solid, glass and reach-in

  • Passage doors are the standard entry door for staff. Look for a strong closer, a good gasket, a heated threshold (for freezers), a kick plate and a lock if you need one.
  • Glass reach-in doors let customers grab drinks and dairy from the front of the box while you stock from behind. They’re the workhorse of grocery and convenience stores. DOE rules require walk-in cooler glass doors to be double-pane with heat-reflective glass and gas fill, or triple-pane. Freezer glass doors must be triple-pane.

Glass door replacement: Q replaces glass doors on grocery and convenience store walk-ins. If your doors are fogging, sweating, not closing or have broken glass, call us at (945) 394-0396.

Energy efficiency features worth asking about

  • ECM (electronically commutated) fan motors, which DOE requires for many walk-in fans
  • LED lighting with an occupancy sensor or timer
  • Strip curtains or air curtains at the doorway
  • Door-ajar alarms and temperature monitoring
  • Refrigeration systems that meet DOE’s annual walk-in energy factor (AWEF) minimums

What Q does and doesn’t handle

Here’s how Q handles walk-ins:

  • New only. Q doesn’t sell used walk-ins.
  • Installation: Q installs the walk-in itself.
  • Not included: permits, electrical work and concrete. Plan to have a licensed electrician and any other contractors your project needs, and check permit requirements with your city.
  • Lead time depends on size and customization. Call early if you have an opening date.

Walk-in cooler checklist

  • What you’ll store, how much, and how often deliveries come
  • Inside dimensions, ceiling height and door location
  • Indoor or outdoor
  • Floor needed (yes for most freezers and above-grade installs)
  • Self-contained or remote refrigeration
  • Number and type of doors (passage, glass reach-in)
  • Electrical service ready (by your electrician)
  • Permits checked with your city

Talk to Q about your walk-in

Bring your measurements and photos of your space to our Irving showroom, or call (945) 394-0396. Browse walk-in coolers, commercial refrigeration and reach-in refrigerators.

Sources

Frequently asked questions

Do I need a floor in my walk-in cooler?

Often not, if the cooler is indoors on a concrete slab at ground level. Freezers almost always need an insulated floor, and any walk-in above grade needs one.

What temperature should a walk-in cooler hold?

The FDA Food Code requires cold TCS foods to be held at 41°F or below. Many operators set their coolers lower to build in a safety margin.

Does Q install walk-ins?

Yes. Q installs the new walk-ins we sell. Permits, electrical and concrete work aren’t included.

Can Q replace the glass doors on my store’s walk-in?

Yes. Q replaces glass doors on grocery and convenience store walk-ins.

How long does a walk-in take?

Lead time varies with size and customization. Call us with your dimensions and we’ll talk through timing.

Call NowDirections